Black Box Vac Source

[michael_schwartz]

Jim,

I have the check valve in my vac box with two motors in each chamber. 90% of the time I use only two of the motors. I normally switch on the 2nd set of motors (which opens the check valve) when I go to cut through smaller parts. It sticks them to the table like glue.

I am glad to hear that you get by with 2 motors most of the time. I plan to try to nest smaller parts within 24x48 zones, and I am wondering at what point parts become small enough that all 4 motors are required. I am going to start out with the two motors I have.

I don't mind cutting drawer parts on the table saw if I have to. As long as I can hold nested parts larger than 1-2 square feet I will be happy.