Quote Originally Posted by michael_schwartz View Post
I recently redid mine, and I used.

2x 5x5 sheets of 3/4" baltic birch plywood cut to make an oversize support board spanning between the table legs, measuring about 104" long. I joined the two sections using biscuits. I bolted this "support board" to the table using every available bolt hole, which was somewhere in the neighborhood of 50.
I was wondering about the bed size. In the assembly manual there is a CAD drawing that shows the mounting of a 4' x 8' sheet of decking for the PRS Standard 96-48-6. For your 10' x 5' deck did you need to move the table cross supports on each end farther out to support the bigger deck? Also, do you think a 4' x 8' bed is good enough?