Hi all,

I'm setting up a new vacuum table and was wondering your opinion(s).

I have a 5x12 PRT and want to be able to vac-down anything from small parts all the way up to the 5x10 sheets of mdf.

Are there any drawbacks to having more zones than fewer?

My idea is to have 25 zones instead of the normal 4 or 8. I would make a bunch of approx. 12"x24" tile-like zones with my smaller CNC and then bolt them down onto the bed of the PRT, and then do a thin surfacing run and go from there.

alrighty, lemme know what you think!

-JAMES