A new twist on old design we used to do this with a hand router and template
Senior Member
Jewerly Box
A new twist on old design we used to do this with a hand router and template
Last edited by dan_nelson; 10-14-2011 at 09:56 PM.
Senior Member
Very cool! Aren't Bots fun!Russ
Senior Member
Dan,
VERY NICE!!!!!
It would be an interesting exercise to create the toolpaths to make this on the Bot.
Don
Diamond Lake Custom Woodworks, LLC
www.dlwoodworks.com
***********************************
Life is not a journey to the grave with the intention of arriving safely in one pretty and well preserved piece; But to skid in broadside, thoroughly used up, worn out, bank accounts empty, credit cards maxed out, defiantly shouting "Geronimo"!
If you make something idiot proof, all they do is create a better idiot.
Senior Member
Dan,
I think i have this design or something similar in one of my design template books but never got around to making it, very nice. I like the contrasting wood. How did you accomplish your lid holding, with a dowel? How does it stay connected to both pieces yet stil turn? good job!
Senior Member
jewerly box
thanks for all the nice words. yes the covers are held by dowels .1562 brass. drilled .75 deep into a 1.5" base. tool paths were done in VCPRO .5" compression. 180 in/min. And a .1562 end mill for the holes.
Senior Member
Dan...
Nicve work! Interesting design. Thanks for posting.
Gary Campbell
GCnC Control
GCnC411(at)gmail(dot)com
Servo Controller Upgrades
http://www.youtube.com/user/Islaww1
"We can not solve our problems with the same level of thinking that created them"
— Albert Einstein
Posting Permissions
Reply With Quote
