Don...
By the way, I cut 7 sheets of "Black Box" melamine today. 3 of these were FlipOp First. Other than tossing 85 lb sheets over on the table, I thought it was painless. The only change to the parameters we talked about on the phone would be to bring the trim amount up to .100 -.125" as I have more variation in the sheets than I thought.

Bill...
Don is right. If you use the feature you need to check the trim sheet box. I also use the pins only option having 3 pins in the X and 1 in the Y. If you dont select pin area only, the Link will trim the complete X and Y zero sides to allow location on the table. You could line this up with a cut edge, or V groove like Don.

Good Luck!