Hi All. I tried again to run the 3.8 software without my hub and no go. Made same noises. In a private message Brady was telling me about motors, values etc and something came up that I am wondering if others that are having issues with the 3.8 have in common with me. I have a 2007 PRS standard and my motors are the ones that have a label that says 0.5" / step. Brady was telling me about this mark on the label and that it may have another marking that says 1.5 amp. Mine does not say that. But I am wondering if the motor amps is problem? Shopbot uses a 2 amp motor now. My number on my motor is A7243-9412KTG.
I am not sure if by any chance the 1.5 or 2 amps would make difference with software. When I checked my packet to see comms I am at 13.8