Results 1 to 10 of 58

Thread: Desktop Jigging--Pics?

Threaded View

  1. 04-04-2014, 10:07 AM #34
    bob_dodd
    bob_dodd is offline Senior Member
    Join Date
    Aug 2004
    Location
    Northern , new jersey
    Posts
    220

    Default Vertical Jig

    Scott when you get yours done with the cam clamps , please post pic .

    I needed to machine some holes in a pc 4 3/8" tall in the DT , I made a pocket in a jig that I could mount vertical off the edge of the table ( be careful there are moving parts down there ) This also gives me good registration of parts
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Was this your jigging set up?
    By scottp55 in forum ShopBot Desktop
    Replies: 8
    Last Post: 09-25-2016, 05:20 AM
  2. More Pics of 2006 PRT
    By wireguy in forum For Sale/Wanted - ShopBot-related items only
    Replies: 0
    Last Post: 11-18-2015, 10:56 AM
  3. Duh! Never seen these pics before:(
    By scottp55 in forum ShopBotter Message Board
    Replies: 5
    Last Post: 01-23-2015, 10:10 AM
  4. A few more pics of progress.
    By dubliner in forum Archives2007
    Replies: 1
    Last Post: 08-18-2007, 07:34 PM
  5. Dove tail jigging on the old SB ?
    By birdsofplay in forum Archives2003
    Replies: 10
    Last Post: 11-19-2003, 05:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules