If that bit is anything like the 'In Groove' line, I would err on the side of slow/caution when using it. I for one would certainly not do any plunge cutting whatsoever with it.

If your intention is to do some edge forming with it, consider programming the tool to come in from the edge using a lead in so that it ramps into the cut. Use your CAM program to get the majority of the action and if need be, hand code the lead in.

Lay the bit on a flatbed document scanner, and bring the JPG into VCP/Aspire. Trace it, scale it & make a Form Tool in the tool database. Then you can preview your toolpath using the toolpath simulation in the program.

-B