Eric,
Your suggestion for feeds and speeds are about right.
I'm thinking the problem is the bit. Onsrud is my choice. I use VCarve Pro. Perhaps he should visit Vetric, Vcarve Pro and post over there.
Not at all sure this is a thread for me.
Joe
Senior Member
Eric,
Your suggestion for feeds and speeds are about right.
I'm thinking the problem is the bit. Onsrud is my choice. I use VCarve Pro. Perhaps he should visit Vetric, Vcarve Pro and post over there.
Not at all sure this is a thread for me.
Joe
Reply With Quote
