Newbie needs help combining multiple toolpaths

[mFairman]

I am trying to cut 3" wide bullnoses in 2" thick foam. I have the rails drawn for multiple cuts and the profiles too, but I ran 10 individual toolpaths to cover the entire 96"x 48" sheet. I want to be able to combine all 10 toolpaths so I don't have to run them 10 times. When I tried to grab all 10 rails and profiles and run a toolpath, it came out wacky. I don't know how to run the same toolpath multiple times across on entire sheet. I am attaching one of the toolpath files.

[srwtlc]

You could do this with some editing of the .sbp file with an offset and repeat of the single toolpath, but depending on the software you are using, you should also be able to array copy the component or the toolpath to do this and then post out one file that does it all.