Richard, et al....
I only have eCabinets files for this project that are incomplete at best. It was a project that in the long run, turned out to perform much better and run quieter and cooler than even I had expected. Even though I had made, sold and installed a number of these systems for profit, I decided that the ShopBot community could benefit from the design so I put all the info I have on the forum to allow it to be open source.
I would be open to assisting someone that wanted to take the design and turn it into PartWorks compatible vectors to share with the ShopBot community. (improvements welcomed) Even more so with someone that would accompany the vectors with some written instruction and/or explanation. With that said, I would NOT be open to those that wanted to profit from my original design. This "open source" vacuum idea was born with a thread started by Brady Watson and only contributed to, albeit with a few variations, by me.
This design is my intellectual property, and I have given it freely to this community for non-commercial use. Permission for commercial use of the design has not and will not be given.
Daren seems to have made a great start to my intended end, maybe he can be convinced to bring the project to the next level.
